Written By:
Date Posted: September 4, 2002

In The Box

1x Abit AT7 motherboard
3x 80 wire/40 pin ribbon cable for master and slave Ultra DMA 133/100/66/33 IDE devices
1x Ribbon Cable for 3.5" FDD devices
1x CD for Support Drivers and Utilities
1x USB Cable
1x DIY bag
1x User's Manual for the motherboard
1x Floppy disk of HPT 374 drivers
1x O/I Shield

The box contents are pretty much standard but there are one or two items that stand out here. There was some included cable ties (the DIY bag) which is a good idea, allowing you to tie off and secure your cables in a tidy and safe manner. Also of note are the black, flat IDE and FDD cables. These are just standard ATA133 leads but look very nice, emblazoned in silver with the Abit logo. The manual is very good, packed with information about the board though there were quite a few "generic" pages in there e.g. flashing the bios guide was done with a P4 board. The driver disk has some useful extras with it, such as Norton's Anti-Virus 2002 which is nice to see, as well as Abit's hardware monitor which works well.

Previous Page - The Technology

Next page - The Motherboard